Newheek manufacture high quality X Ray Grids.Welcome to purchase.

HomeBlog ›How to install the grid on the 500mA radiology table?

How to install the grid on the 500mA radiology table?

Recently, some customers have asked how to install the grid on the film bed? The grid of the film bed is mainly installed on the car, and the wire grid can also be installed inside the car. Some customers ask, how is this installed? Let’s talk about it for everyone. First of all, you have to open the car and put the film box. This is basically the same as installing the chest piece, but this is pulled back and forth, you have to lie on it to make a film. Let’s take a look at the classification information of the filter grid!
According to the structure:
Convergent x ray gridundefineds defocused
1 convergence grid: each lead strip is inclined to the focus, that is, the lead strip extension line is concentrated in the focus

2 parallel grid: each lead strip is parallel to each other in the vertical plane

3 cross grid: composed of two parallel grids, the lead strips are 90° apart

4 arc grid: from the center to the outward expansion of the same radius, tile-like

According to the material:

1.  commonly used grids: internal spacers are composed of non-metallic materials, such as wood chips, paper sheets, plastics and other non-metallic low-density materials;

2. full metal grid: the internal spacer is metal material: aluminum sheet. Its high strength and good moisture resistance;


(+86) 18953613955